GETITIMER(2) MachTen Programmer’s Manual GETITIMER(2)

NAME
getitimer, setitimer - get/set value of interval timer

SYNOPSIS
#include <sys/time.h>
#define ITIMER_REAL 0
#define ITIMER_VIRTUAL 1
#define ITIMER_PROF 2

int
getitimer(int which, struct itimerval *value)

int
setitimer(int which, struct itimerval *value, struct itimerval *ovalue)

DESCRIPTION
The system provides each process with three interval timers, defined in
<sys/time.h>. The getitimer() call returns the current value for the
timer specified in which in the structure at value. The setitimer() call
sets a timer to the specified value (returning the previous value of the
timer if ovalue is non-nil).

A timer value is defined by the itimerval structure:

struct itimerval {
struct timeval it_interval; /* timer interval */
struct timeval it_value; /* current value */
};

If it_value is non-zero, it indicates the time to the next timer expira-
tion. If it_interval is non-zero, it specifies a value to be used in
reloading it_value when the timer expires. Setting it_value to 0 dis-
ables a timer. Setting it_interval to 0 causes a timer to be disabled
after its next expiration (assuming it_value is non-zero).

Time values smaller than the resolution of the system clock are rounded
up to this resolution (typically 10 milliseconds).

The ITIMER_REAL timer decrements in real time. A SIGALRM signal is de-
livered when this timer expires.

The ITIMER_VIRTUAL timer decrements in process virtual time. It runs on-
ly when the process is executing. A SIGVTALRM signal is delivered when
it expires.

The ITIMER_PROF timer decrements both in process virtual time and when
the system is running on behalf of the process. It is designed to be
used by interpreters in statistically profiling the execution of inter-
preted programs. Each time the ITIMER_PROF timer expires, the SIGPROF
signal is delivered. Because this signal may interrupt in-progress sys-
tem calls, programs using this timer must be prepared to restart inter-
rupted system calls.

NOTES
Three macros for manipulating time values are defined in <sys/time.h>.
Timerclear sets a time value to zero, timerisset tests if a time value is
non-zero, and timercmp compares two time values (beware that >= and <= do
not work with this macro).

RETURN VALUES
If the calls succeed, a value of 0 is returned. If an error occurs, the
value -1 is returned, and a more precise error code is placed in the
global variable errno.

ERRORS
Getitimer() and setitimer() will fail if:

[EFAULT] The value parameter specified a bad address.

[EINVAL] A value parameter specified a time that was too large to be
handled.

SEE ALSO
select(2), sigvec(2), gettimeofday(2)

HISTORY
The getitimer function call appeared in 4.2BSD.

4.2 Berkeley Distribution December 11, 1993 2